Fuel pressure tester

[Dan 6511]

Here are some of the bits I got, all are eBay item numbers:

Banjos: 132813620405 You need 6mm hose ID for both, 1x M10 and 1x M8

T piece: 264393424153

Valve: 283550283654

Hose: 140850656095

Hose clamps: 222439718697 10mm-12mm size fit the hose above

That will make up everything you need apart from the actual gauge. I used this: https://uk.rs-online.com/web/p/analogue-positive-pressure-gauges/2473602/

They do the same gauge without calibration for 55 quid less and I doubt they do anything to them apart from test and supply a certificate https://uk.rs-online.com/web/p/analogue-positive-pressure-gauges/2435919/

[Corsair]

Dan Thanks a million for looking that up again for me as I know I am going to need it. Never thought of RS yet they have a warehouse next to me in Gatwick. Better to pay for something that works than pay for mistakes later. I'll update on the forum.
Thanks again Chris

[Corsair]

djk73
Checked out your snap on link but stll looking for uk offers. Thanks hope there is something out there.
Chris

[MikeWard]

Go on eBay and look at snap on fuel pressure testers, if you are lucky you might pick one up for £70 ish

There is a Snap-On gauge on eBay at £69.99 but open to offers, however it is the gauge only and lacks the other components. Could still be a good buy if you chuck an offer in.

https://www.ebay.co.uk/itm/Snap-On-Tool ... 4316536654

MT337 / MT337A are the Snap-On part numbers.

[Daniel Shane]

A1 hydraulics made these for me in the past. Under 30 quid if I remember

[Corsair]

Thanks for all your replies. I put in an offer for the Snap On but not accepted. It was of course in unknown condition --so.
Went with the cheaper gauge from RS components near me who also supplied some of the hardware. Banjos and tap from e bay .Thanks Dan for your help. The Wika gauge company is 6 miles from me so if calibration is out can get it sorted --maybe cheaper on a walk in begger basis! Will update.
Chris