DPNW poly bushings for ARB - LCA

[bozzzydmc]

19mm me old chip ... 55 ft lb when tightening up .... should be 2no nuts on each end, one locks the other down ...

[jerzybondov]

Nice one. Cheers Bozzy!

[Dan 6511]

Your taking the arb off!!?? Decided to swap those blue bushes out for the DPNW ones then?

[DeLorean Cars]

Edit: pointless comment.

[jerzybondov]

Your taking the arb off!!?? Decided to swap those blue bushes out for the DPNW ones then?

No I'm leaving the blue ones in - but my DPNW instructions tell me to loosen the whole ARB off to install just the front bushings. Makes it easier to do the fitting I guess...

[jerzybondov]

Edit: pointless comment.

It wasn't one about how I should definitely put Toby's in and take the others out was it?

[bozzzydmc]

Edit: pointless comment.

LOL ...dont know why that post tickled me ...

Its a bit like when you see a blank page at the end of a book and it says on it "This page is intentionally left blank"

[DeLorean Cars]

I wrote "19mm" then realised I hadn't spotted the next page of discussion

How about this then: A geninie sign in the middle of a field, in the middle of nowhere reading

"PLEASE DO NOT THROW STONES AT THIS SIGN"


I would HIGHLY recommend replacing the ones in the lower arm, otherwise you're not getting even half the advantage of Toby's kit. If you think about it, it's the ones in the arm that do most of the work - the original ones under the U-brackets can only deflect a few mm anyway.

[bozzzydmc]

Oh and its fun trying to flex the 'split' bushings over the anti roll bar, tough little burgers them

[DeLorean Cars]

Oh and its fun trying to flex the 'split' bushings over the anti roll bar, tough little burgers them

Circlip pliers work a treat (the inny-to-outy flavour)