andyd wrote:Hi guys
Thanks for input. At the risk of appearing *really* stupid, I was referring (mild vs stainless) to the large car-width bracket to which the "bucket holders" attach.
Lamp > bucket > "bucket holder" > panel in question.
You can see it in stainless behind my rusty bucket holders in the pic above. I am presuming this is not stainless from Dunmurry. (Tho not imortant really, other than the accuracy of where the mounting holes are drilled)
I would like to see if there is any wiggle-room in where I mount the bucket holders to give a bit more access to the adjustment and mounting screws.
I dont want to remove the fascia (and the bonnet, by necessity) to adjust the beam. So I may play a hairdryer over the very edges to soften them to get screwdriver access.
Check here -->
https://www.flickr.com/photos/researchp ... 362615561/
It is super tight for access ie. None! (And rusty buckets be GONE!!)
I am in the process of mutilating the buckets to get the Hella H4s to fit, with the rubber boot over the back to keep the water out...
Delta Delorean wrote:Do you use the hella units with the small bulb beside the big one? I had to drill a extra hole in the bucket to feed wire true for the small bulb.