I’ve tried to mount the steering rack this afternoon, but after spend more than3 hours; it’s not finished yet… Replace the little pin anyway; I thought the other one was too short.
DSCN4358.JPG (42.62 KiB) Viewed 4016 times
New poly for the steering rack from Ed Uding
DSCN4359.JPG (66.84 KiB) Viewed 4016 times
DSCN4360.JPG (68.06 KiB) Viewed 4016 times
DSCN4361.JPG (50.63 KiB) Viewed 4016 times
DSCN4362.JPG (50.47 KiB) Viewed 4016 times
DSCN4363.JPG (96.61 KiB) Viewed 4016 times
DSCN4364.JPG (99.63 KiB) Viewed 4016 times
The other side isn’t aligned to the holes
DSCN4367.JPG (87.82 KiB) Viewed 4016 times
However the driver’s side looks good, so decided to remove the bolt
DSCN4368.JPG (46.62 KiB) Viewed 4016 times
And this is much better
DSCN4369.JPG (81.66 KiB) Viewed 4016 times
DSCN4371.JPG (71.55 KiB) Viewed 4016 times
Unfortunately, now the driver’s side doesn’t want to get beck inside.