Hello
I'm sorry to report that I'm having to sell 3193 in a half completed state. This car came to me as a wreck and I've restored it 50% to the best of my ability and to the best standard my wallet will allow.
Sadly It's going to have to go because as of the first week in March it will have to where to be stored.
Naturally this is the same old story about starting a project and not finishing it. On the up side most of the expensive work has been completed (see below). It's just(!) a matter of finishing it.
you can follow the early stages of the project here:
http://www.deloreaneurotec.co.uk/forum/viewtopic.php?f=41&t=1020&start=70
more photos here:
https://www.flickr.com/photos/32731331@N04/
VIN 3193
Grey interior
Manual
The good:
Frame repaired and powder coated by DMC Europe.
Wheels powdercoated.
pirellis all around
Stainless door bracket thing (the thing that's in the roof) from DMC Europe
New torsion bars (passenger side from DMCH driver's side from Hervey)
new windscreen
new 'sports' radiator (DMC Europe)
new radiator fans (from DMC NW)
SPAX all around
Eibach springs all around
polyeurothane bushes all around
new bearings all around
new upper and lower ball joints (hervey)
new headlights
new fusebox
new dash
improved lock solenoids (DMCNW)
brake calipers have been re-built with stainless pots.
new brake discs all around.
new fuel pump and flexible fuel lines (at the pump end)
new fasteners associated with the frame.
all the galvanised braketry has been re-plated and look as good as new.
lower front link arms have been boxed in (in case you're wondering)
the heater box (with new matrix and evaporator) has been re-built.
new rivnuts all around (not something you'd think about - but was a major pain in the rear end for me!)
carpet partially installed.
other odds and sods I've had to replace that no-one will care about...
the bad
Needs either the engine i have for it restored and putting back in or a new engine entirely.
front and rear bumpers need striping and re-painting.
needs new seats/or covers
some interior parts need sourcing (including the binnacle) or repairing.
needs window motors
needs fuel tank enclosure plate.
needs upper louvre (have one but it's knackered)
and just all in all needs finishing off......
I'll throw in a second PRV (the EFI 2.9 170bhp vesrion from the mk1 lag) if anyone buys the car.
viewing is advised to take account of all the parts that i have that i haven't listed. :/
looking for £12,000
not for the feint hearted.
need to sell this car with in a month, sadly. The house that it is currently residing at is being sold and i do not have accommodation to carry on with the project.
PM me if you're seriously interested.
thanks for looking.
Dave.