De Lorean EuroTec

No idea how you lot call 'em, i call em labels. I recently made these with my dual extruder 3D printer. it was tricky to get the calibration right, that's wh i have lots of fails...

If you want one, shipping is more expensive than the used material, but i could make a few and send them to Arran for combined P&P.

Definitely reckon Arran would shift a few of these - I'd have one!

I'd have one

Key ring "Tags", I'd call them. I'd be interested in one.

As you are the master of electronics Rob, I challenge you to make a light-up version

light up version eh? interesting.. i wonder where to put the battery

RobvdVeer wrote:light up version eh? interesting.. i wonder where to put the battery

Print with glow in the dark plastic

That's good thinking

I'd have one!

I may order some of that glow in the dark stuff when i get the quality up to an acceptable level, then i'll be back

Very nice rob. I've got a few I've created on the laser cutter using the same technique I used for the light switch. Wouldn't be too hard for me to create an illuminated version, but these look excellent! Getting the calibration right in order to have such an accurate level of definition must have been hard. Great job!