De Lorean EuroTec

Hi all

I'm trying to get some 30mm diameter aluminium rods lathed down in a conical shape to 10mm at the other end

It is 6 pieces all 60mm long

Anyone got any ideas please

Mike

Get them sent to me Bozzy, my mate can do it
I expect Barren could as well

That would be great Al !

I will give you a call to see how best to send this

Maybe I should run a competition to guess what they are for

Ok I can send back no issues via courier, just need to get them to me.
Btw the labour prices are increasing daily, I predict £30ph by Xmas!

that I like x

bozzzydmc wrote:Maybe I should run a competition to guess what they are for

Green tubes?

Butt plugs?

MikeWard wrote:

bozzzydmc wrote:Maybe I should run a competition to guess what they are for

Green tubes?

Tiny little 60mm long tubes maybe Mike

Sell me your dash boxes xx

I'll wiz em down on my lathe in exchange for you booking for Carfest

If you put your mind to it, you can make pretty much anything, dad, dad, daddy o!

Today I decided to sort out some door handles I got for my Ferrari restoration. They are as rare as a tax refund for JZD!
After searching high and low I managed to track down some from a guy who’d changed his 10 years ago and still had the old broken ones. After a bit of negotiation I managed to get them for several thousand pounds less than a working second-hand set.
However the cheap Mazak operating paddle was completely missing on one (seized and snapped off long ago) and the other had a single snapped leg and was bent and worn out.





So I roughed some new ones out of a solid Stainless Steel Bar, with nothing but a hacksaw and file.



And made two to replace the missing one and the one with one arm.





Result

So your cones will be a doddle Bozzy!