Page 1 of 14
#CANCELLED# - Sorting out Aaron May's Car at Eurotec 2010
Posted:
Sun Mar 21, 2010 9:34 pmby tourettes tony
After discussions the weekend with various members we will be sorting Aaron May's car out.
It will be done on the friday.
Spares we need:
dizzy i have a spare
rotor arm and cap
coil
spare injectors
spark plugs
leads i have
cpr
oxy sensor
idle motor or aux air valve
plenium chamber i have
any other suggestions apreciated TT and thanks to all who offered to help out
Re: sorting out Aaron May's car- tec at Eurotec 2010
Posted:
Sun Mar 21, 2010 9:43 pmby delorean12uk
Tone, spare vac hoseing, as well as tools, gazebo, tarpoline just in case of adverse weather conditions. And if we are successful in getting Aarons car working he must honour this by performing 'Rock star' on the wii, including Lyrics!!
Re: sorting out Aaron May's car- tec at Eurotec 2010
Posted:
Sun Mar 21, 2010 9:44 pmby Dan 6511
Gallon of unleaded gasoline and a box of matches....
Re: sorting out Aaron May's car- tec at Eurotec 2010
Posted:
Sun Mar 21, 2010 9:51 pmby delorean12uk
Dan 6457 wrote:Gallon of unleaded gasoline and a box of matches....
Dan has got a point, instead of repairing Aarans car we could use it as an effigy, Aaran could still do 'Rock Star' afterwards as well
Re: sorting out Aaron May's car- tec at Eurotec 2010
Posted:
Mon Mar 22, 2010 12:22 pmby Admin-bloke
I will use this post as a reminder for myself to bring:
I will bring:
Fuel pressure tester
Known working OEM CPR (Dans car)
Injector Tester (if I get to change the O rings in it)
Spare Idle ECU
Spare Ignition Amplifier (if Shane hasn't got this)
Spare Chips to repair ECU's if time permits
Various Multimeters
Wiring toolbox with loads of electrical crimp stuff...
Spare fuel hoses
Spare Relays
Spare inline fuse holders inc fuses etc....
If others could bring spare O rings for fuel distributor, spare working fuel ecu, loads of copper washers for the K-Jet that would be a start !
Re: sorting out Aaron May's car- tec at Eurotec 2010
Posted:
Mon Mar 22, 2010 9:24 pmby bozzzydmc
Sure im up for helping out here ...
Bearing in mind Ed U is coming perhaps he can bring over any other bits we need such as O Rings and copper washers etc
Mike
Re: sorting out Aaron May's car- tec at Eurotec 2010
Posted:
Mon Mar 22, 2010 9:41 pmby hana 5284
i have a box of various rubber o rings all sizes i will bring
Re: sorting out Aaron May's car- tec at Eurotec 2010
Posted:
Mon Mar 22, 2010 9:43 pmby bozzzydmc
Eh up Tys ... just make sure they are suitable for unleaded fuel eh x
Re: sorting out Aaron May's car- tec at Eurotec 2010
Posted:
Mon Mar 22, 2010 10:41 pmby hana 5284
bozzy dont ask me tec question like that i think they are i will look and let you know.
just a thought though if aaron hasnt run the car for a couple of years will the fuel be any good or should he empty it out and refill it before he gets there in june.
Re: sorting out Aaron May's car- tec at Eurotec 2010
Posted:
Mon Mar 22, 2010 10:52 pmby bozzzydmc
Oooh ... he needs to def hand pump it all out before he tries to start it ...
Then clean out the tank and fill it with some fresh stuff
Hope he checks this thread out before he tries starting it
bozzzy