De Lorean EuroTec

Passenger seat complete with new grey cover - perfect condition. Note - does not have the rear panel. - £200
2 x new grey lower seat covers - £50 each
1 x used grey seat cover set - not including back plate. Good clean condition with no tears or scuffs. Just 2 small areas need the stitching redone - about 50mm long each on lower seat section - £75
1 x front nose cone - needs repaint but good shape - £175
1 x exhaust in good condition - £100
2 x front indicator orange plastic housings - good condition - £20 pair
2 x front callipers - good condition for rebuild - £80 pair
Front wire grill, good condition - £30
Front brake disc - new x 1 only - £30
2 x new front hub / bearings, no studs included - QWB 244 ref - £60 pair
Set of 4 original headlamps and holders in good order - £40
1 x air con compressor - believed good - £80
2 x exhaust manifolds with front pipe good - £100
Main engine harness - £80
4 x door struts, 2 bonnet struts, 2 engine cover struts - all seem good used items - £60 lot
Set of front and rear wheel arch filler pieces (that go between the body tub and the stainless panels - £30
Handbrake cables x 2 - used condition - £30 pair
New distributor cap and rotor arm - £20
2 front and 2 rear brake hoses, new - rubber with coil of wire on rear, coil of plastic on front - £40 for all
I will consider an offer for all parts, and will chuck in all the various other odds and sods I have.
Post will be on top and we can discuss as you need bits. Alternatively pick up from near Chippenham, Wiltshire UK
Phone Andy on 01249 783305 or email andy@theonetocall.com

bigglesdmc wrote:2 x front callipers - good condition for rebuild - £80 pair

you can pick them up fully refurbed for that price!

I didn't know that! In that case £20 pair for the callipers! I need to move this stuff on but need the money as well! So please make realistic offers if you spot something like this - I'm not out to rip anyone off!

What vin is the engine loom from?

Is that the exhaust you bought off me on ebay?

Hi - I'm afraid I don't know which engine the loom is from as I bought it a while back as a spare. I can take a photo of it if that helps.

Yes it is the same exhaust - still in great shape and I should add that it has the stainless steel bits on the end of the pipes.

Good luck with the sale.

Could you confirm if the hubs are brand new hubs with new bearings already pressed in please. Thank you.

Hubs are brand new with bearings pressed into position - I can send a photo if it helps.