Page 11 of 36
Re: Vin 5063
Posted:
Fri Nov 24, 2017 1:16 pm
by arranj
That is one of 2 gaskets that go on the W shaped pipe:
Re: Vin 5063
Posted:
Fri Nov 24, 2017 7:03 pm
by Domi
Good choice of picture to show how the gasket goes
Re: Vin 5063
Posted:
Sat Nov 25, 2017 1:34 am
by gruffalo
arranj wrote:That is one of 2 gaskets that go on the W shaped pipe:
Is that a dude on the right?
Re: Vin 5063
Posted:
Sat Nov 25, 2017 10:15 am
by A Van
Did the Volvo one fit?
Sent from my iPhone using Tapatalk
Re: Vin 5063
Posted:
Sun Nov 26, 2017 11:28 pm
by gruffalo
What Volvo piece are you referring to? The answer is most likely no. The only parts I have used so far are some screws and the sensor in the thermostat housing.
Re: Vin 5063
Posted:
Sat Dec 02, 2017 10:45 pm
by gruffalo
I’m installing a heater / air conditioner in my garage right now, and doing some home maintenance, but still some progress. The two hoses for the heater are replaced and the spark plugs installed. I’m waiting for some pieces to finish off the rest. In theory I could be ready to start the engine in a few days. So maybe this year?
Re: Vin 5063
Posted:
Sat Dec 16, 2017 10:24 pm
by gruffalo
What’s this for?
Re: Vin 5063
Posted:
Sat Dec 16, 2017 10:28 pm
by gruffalo
A close up
Re: Vin 5063
Posted:
Mon Dec 18, 2017 3:51 pm
by cis6409
Number 2 in that pic with the black connector is the connection for the diagnostic port ..
Very handy for telling you rpm , dwell etc
One part comes from the main loom and the other side comes out of the bottom of the diagnostic port which is located behind and to the left of the spark distributor , it's mounted to the rear of the left hand side head
The other white plug pic on the close up I'm not 100% on but I think it's the connector for the hot start relay via the cold start valve ..
Shane
Re: Vin 5063
Posted:
Mon Dec 18, 2017 5:50 pm
by gruffalo
Thanks! The white one can be seen here too