De Lorean EuroTec

All right, thanks again for your help

I have most of the part to rebuild the front now.
This morning, I went to the garage to mount the lower ball joint on the arm.
I didn't forget the Duralac
Just did this so far.

I think I made a mistake on my last order?
I have ordered 4 Spax Top Washer (see pic below)
Nevertheless I think I need 8 of them, 4 by shock.
Can you please confirm this? Thanks!

I just check the store page, and it looks like it does mount like this:

So, it it does I have everything I need.
I thought it was like the old one. 4 by shock.

Yes, 2 per shock, it’s the same as the rear ones now, these are much larger bushings.

Thanks again
Here are the progress today:


I didn't forget the Duralac








The bolt behind the nyloc is dead (Torque to 60Nm)


I thought I might replace it with this one:
https://www.deloreango.com/fr/stainless ... cknut.html
Do you know if ot will fit on the roll bar?
Thanks again

That nut is only suitable for the idler pulley - it is the wrong thread for the anti-roll bar.

For the anti-roll bar you need a normal pitch M12 nut - i.e. M12x1.75mm. It should just be one nylok nut - SP10027. But if you wanted to match the recall - http://www.dmcnews.com/bulletins/SC-01-11.81.pdf - then instead you need:

2 x SP10050 - https://www.deloreango.com/fr/stabilize ... -thin.html
2 x SP10330 - https://www.deloreango.com/fr/stabilize ... thick.html

All right, thanks again.
On my car, I had the thin one and nylok only.

I received my order, thanks again for the fast shipping
Stabilizer bar is done. Torque done & Loctite 270 It won't move!!

Next:


New torque wrench:






Stuck here for now, my two drill have passed away ...