DMC keyring labels

[RobvdVeer]

No idea how you lot call 'em, i call em labels. I recently made these with my dual extruder 3D printer. it was tricky to get the calibration right, that's wh i have lots of fails...

If you want one, shipping is more expensive than the used material, but i could make a few and send them to Arran for combined P&P.

keyring

image.jpg (508.13 KiB) Viewed 3470 times

image.jpg (701.89 KiB) Viewed 3470 times

[jerzybondov]

Definitely reckon Arran would shift a few of these - I'd have one!

[MikeWard]

I'd have one

[Dangermouse]

Key ring "Tags", I'd call them. I'd be interested in one.

As you are the master of electronics Rob, I challenge you to make a light-up version

[RobvdVeer]

light up version eh? interesting.. i wonder where to put the battery

[ALEXAKOS]

light up version eh? interesting.. i wonder where to put the battery

Print with glow in the dark plastic

[RobvdVeer]

That's good thinking

[Admin-bloke]

I'd have one!

[RobvdVeer]

I may order some of that glow in the dark stuff when i get the quality up to an acceptable level, then i'll be back

[flux3d]

Very nice rob. I've got a few I've created on the laser cutter using the same technique I used for the light switch. Wouldn't be too hard for me to create an illuminated version, but these look excellent! Getting the calibration right in order to have such an accurate level of definition must have been hard. Great job!